Hello all. Sorry for my late response to this mail. I was out of the country . I just resumed work this week.

Bellow is an attachment with the output of the above commands. Please take a look at them.

On Nov 7, 2017 5:07 PM, "Ilario Gelmetti" <iochesonome@gmail.com> wrote:

On 11/07/2017 11:00 AM, Nges B wrote:
> No that is the IP of the router.
>
> I got that from the netdiscover command which was tied to the TP link
> router.

Ok, that's great! Netdiscover is a very useful command :)

But for being sure that the IP you saw is not another client, can you
run it again and wait until it ends?
Then please save the output and send it to this mailing list (remember
to disconnect from any other network apart from the WDR3600 one,
preferably by ethernet cable, before running netdiscover)?

Additionally, while connected to the router, can you save the output of
these commands and then send the output to this mailing list?

ip -4 address show scope global

ip -4 route show

cat /etc/resolv.conf

ping -c 3 10.5.5.55

ping -c 3 10.5.0.1

ping -c 3 10.13.0.1

telnet 10.5.5.55

ssh root@10.5.0.1

telnet 10.5.0.1

Thanks!
Ilario

_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users

_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users