in the same room, the wdr3500 and cpe510 connected with more than 100mb/, although it's odd that they never show the same speed on both sides. is there any way better than iwinfo to check it?

cpe510:
wlan0-adhoc ESSID: "LiMe"
          Access Point: CA:FE:00:C0:FF:EE
          Mode: Ad-Hoc  Channel: 48 (5.240 GHz)
          Tx-Power: 10 dBm  Link Quality: 67/70
          Signal: -43 dBm  Noise: -95 dBm
          Bit Rate: 108.0 MBit/s
          Encryption: unknown
          Type: nl80211  HW Mode(s): 802.11an
          Hardware: unknown [Generic MAC80211]
          TX power offset: unknown
          Frequency offset: unknown
          Supports VAPs: yes  PHY name: phy0

wdr3500:
wlan1-adhoc ESSID: "LiMe"
          Access Point: CA:FE:00:C0:FF:EE
          Mode: Ad-Hoc  Channel: 48 (5.240 GHz)
          Tx-Power: 15 dBm  Link Quality: 68/70
          Signal: -42 dBm  Noise: -90 dBm
          Bit Rate: 180.0 MBit/s
          Encryption: unknown
          Type: nl80211  HW Mode(s): 802.11an
          Hardware: 168C:0033 168C:A120 [Atheros AR9580]
          TX power offset: none
          Frequency offset: none
          Supports VAPs: yes  PHY name: phy1



I confirm 15mb in the 2km connection, but it was made between two cpe510s with original firmware (not flashed), not between wdr and cpe. and they were not aligned, but  about 30-40 degrees offset.

i hope it helps!
bruno

On Sat, Jul 15, 2017 at 2:49 PM, Leonardo Taborda <leonardotaborda@networkbogota.org> wrote:

yeah, the link speed. Can you confirm 15mb over 2km is between the cpe510 and the wdr3500?. I like that cpe but i know some features of it may get lost when using openwrt.


El 15/07/17 a las 12:37, bruno vianna escribió:
do you mean the link speed between two of them?

right now it is only 15mb over 2km, but thats because we wanted to have a point-to-multipoint setup. so they're not pointed perfectly to each other, but on the 45 degrees limit. but that might change as we keep looking for other topographies for the network.

On Fri, Jul 14, 2017 at 10:00 AM, Leonardo Taborda <leonardotaborda@networkbogota.org> wrote:

hi bruno

which speeds do you get with that device?

thanks


El 13/07/17 a las 18:22, Nicolas Pace escribió:
Great Bruno!
That sounds Amazing!

Please, if you have any time tell us more about your deployment!.

On Thu, 2017-07-13 at 18:27 -0300, bruno vianna wrote:
The reason I'm flashing these is that we installed a small network in
a favela here last week, and 
the wdr3500 didn't have enough reach. Not only the nearest nods were
far (anything from 200m to 2km), but also all the interference  we
had (it's a really dense neighborhood) made any link with more than
100m very poor. The plan now is to connect the most important nodes
with those.
Are you using the antenna that comes from factory, or using a custom
made one?


_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users

-- 
Cordialmente

Leonardo Taborda Ángel
leonardotaborda@networkbogota.org
www.networkbogota.org

"When there is a will, there is a way"

_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users



--

bruno@pobox.com ▀─█▄██▄▀▄
http://brunovianna.net ─█▄██▄▀█▀█▄
skype: randomico▀─█▄██▄▀█▀█▄▌██─█▌█▌





_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users

-- 
Cordialmente

Leonardo Taborda Ángel
leonardotaborda@networkbogota.org
www.networkbogota.org

"When there is a will, there is a way"

_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users



--

bruno@pobox.com ▀─█▄██▄▀▄
http://brunovianna.net ─█▄██▄▀█▀█▄
skype: randomico▀─█▄██▄▀█▀█▄▌██─█▌█▌