Hi Bob
I have it working on Raspberry Pi's.
Do you have any USB Wifi adapters connected that support mesh or no?
The onboard wifi does not support mesh, you need to use a supported USB
dongle
Regards
On Thu, Dec 21, 2017 at 11:29 PM, Bob Haddleton <bobh(a)haddleton.net> wrote:
Does anyone have LiMe working on a Raspberry Pi 3? I
can boot up the
latest RPI-3 image and get the eth0 port connected to my WAN uplink, but
the mesh doesn't work and the AP is not broadcasting any SSIDs. The SSIDs
all show "*Wireless is disabled or not associated" *and the wlan0-mesh_13
interface shows DOWN on the BMX6 Status page.
I get two errors during init:
[ 10.862080] brcmfmac: brcmf_cfg80211_add_iface: iface validation
failed: err=-16
[ 12.117179] brcmfmac: brcmf_cfg80211_get_channel: chanspec failed (-1)
The brcmf_cfg80211_add_iface error traces back to this code in
cfg80211_change_iface() in net/wireless/util.c:
/* if it's part of a bridge, reject changing type to station/ibss
*/
if ((dev->priv_flags & IFF_BRIDGE_PORT) &&
(ntype == NL80211_IFTYPE_ADHOC ||
ntype == NL80211_IFTYPE_STATION ||
ntype == NL80211_IFTYPE_P2P_CLIENT))
return -EBUSY;
which seems to imply that this can't work (bridging an AdHoc interface).
Or maybe the AdHoc mode has to be set before the bridge is added?
Any suggestions or pointers would be greatly appreciated.
Thanks
Bob
_______________________________________________
lime-users mailing list
lime-users(a)lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users