Fred

Look here for details on which Wifi Adapters to use and a CJDNS/Mesh build

https://github.com/tomeshnet/prototype-cjdns-pi

https://github.com/phillymesh/802.11s-adapters/blob/master/README.md

Regards

On Thu, Mar 7, 2019 at 11:12 PM Daniel Golle <daniel@makrotopia.org> wrote:

Hi Fred,

On Thu, Mar 07, 2019 at 10:02:19PM +0100, fred wrote:
> Hi,
>
> Do you have a recommended chef firmware build and prefered USB wifi
> dongle to wire on a RPI Zero W
>
> https://hackaday.com/2015/11/28/first-raspberry-pi-zero-hack-piggy-back-wifi/
>
> Then it could be a cheap and neat LibreMesh node whith 2 wlan interfaces ?!

USB WiFi is not what you may expect from a mesh router, especially not
if you got two of them and your Ethernet-port also being a USB device
on the same bus...
This may work for simple station mode or APs serving only very few
stations, but for 802.11s/mesh, Ad-Hoc or busy vAPs USB just isn't
good enough.


Cheers


Daniel

>
> Soyons Libre!
>
>
> _______________________________________________
> lime-users mailing list
> lime-users@lists.libremesh.org
> https://lists.libremesh.org/mailman/listinfo/lime-users
_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users

_______________________________________________
lime-users mailing list
lime-users@lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users