5 Dec
2020
5 Dec
'20
8:14 p.m.
SAn:
Hi
On 12/3/20 5:12 PM, amuza wrote:
I tested it. It works ok with BMX6. But not optimally.
I have Router A, B and C with LiMe based on OpenWRT 19.07 with BMX6, no
Babel. They are connected like shown below:
ISP-A ISP-C
| |
RouterA <--> RouterB <--> RouterC
RouterA is connected to ISP-A.
RouterC is connected to ISP-C.
Router-B can reach the Internet via both ISP-A and ISP-C without a
problem, switching gateways automatically when needed.
However, if ISP-A fails, RouterA won't reach the Internet through ISP-C
automatically: it will need a manual reboot :(
And so, the same applies at the other end: if ISP-C fails, RouterC won't
reach the Internet though ISP-A unless you give it a manual reboot.
Hi,
In order to have an Internet-sharing LibreMesh, I have removed
lime-proto-babeld and shared-state-babeld_hosts
And regarding BMX6, I have added bmx6 and lime-proto-bmx6.
By doing a search in menuconfig (/) I have also found the following BMX6
items, do you think I also need any of them?
- bmx6-auto-gw-mode (this one sounds good to me)
- bmx6-json
- bmx6-sms
- bmx6-table
- bmx6-uci-config
- luci-app-bmx6
- luci-lib-libremap-bmx6
- prometheus-node-exporter-lua-bmx6
- ubus-lime-bmx6
I would select bmx6-auto-gw-mode and depending if you are using the lime app or luci
select ubus-lime-bmx6 for the lime app and luci-app-bmx6 for luci.
Good luck!