and it looks like netifd is doing the classical "iw mesh0 set
 channel 48 HT40+"
 
 for the meantime, i just unset htmode, and it everything comes up
 fine (albeit slow, a netperf between the two nodes on the same
 table gives only ~20 mbps, it could be around ~100 mbps if
 properly configured) 
 
 Thank you so much Pau for always being so stubborn about the 
 "ieee80211s" mode support in libremesh, insisting it would be
 better supported than adhoc in the future :) you were right!
 
 in few words, I managed to get LibreMesh working on an 802.11ac 
 equipment, using ath10k and ieee80211s
 
 now, what about ath10k stability? Well, that's left as an exercise
 for the brasilian team :)
 
 From that team, thanks especially to drebs! for allowing me to
 remotely login and try to brick their devices ;)
 
 
 nice, very nice, after recreating the interface manually on both
 sides, but using "VHT80" mode, i get ~100mbps
 
 what follows are the manual steps, i don't think there's anything
 to fix on "our" (LibreMesh) side to properly support this; it's
 even possible that netifd from LEDE is already fixed. so i'll just
 do one of my "horrible hacks" in chef (overwriting the firmware
 file, and such) for the "rede Mocambos" to progress ASAP.
 
 
 iw phy phy0 interface add mesh0 type mp mesh_id LiMe iw mesh0 set
 freq 5180 80 5210 ip l set up mesh0 iw mesh0 station dump
 
 
 root@LiMe-09248f:~# netperf -cCD1
 -Hfe80::32b5:c2ff:fe09:6034%mesh0 MIGRATED TCP STREAM TEST from ::
 (::) port 0 AF_INET6 to fe80::32b5:c2ff:fe09:6034 () port 0
 AF_INET6 : demo Interim result:   91.69 10^6bits/s over 1.001
 seconds ending at 1478709257.529 Interim result:   95.98 10^6bits/s
 over 1.002 seconds ending at 1478709258.532 Interim result:   96.33
 10^6bits/s over 1.000 seconds ending at 1478709259.532 Interim
 result:   96.36 10^6bits/s over 1.001 seconds ending at 
 1478709260.533 Interim result:   96.26 10^6bits/s over 1.001
 seconds ending at 1478709261.534 Interim result:   95.60 10^6bits/s
 over 1.006 seconds ending at 1478709262.540 Interim result:   96.91
 10^6bits/s over 1.001 seconds ending at 1478709263.541 Interim
 result:   97.17 10^6bits/s over 1.001 seconds ending at 
 1478709264.542 Interim result:   96.97 10^6bits/s over 1.002
 seconds ending at 1478709265.543 Interim result:   96.74 10^6bits/s
 over 0.994 seconds ending at 1478709266.538 Recv   Send    Send
 Utilization       Service Demand Socket Socket  Message  Elapsed
 Send     Recv     Send    Recv Size   Size    Size     Time
 Throughput  local    remote   local remote bytes  bytes   bytes
 secs.    10^6bits/s  % S      % S      us/KB   us/KB
 
 87380  16384  16384    10.02        95.95   99.10    88.72
 84.617 75.756 root@LiMe-09248f:~# iw mesh0 station dump Station
 30:b5:c2:09:60:34 (on mesh0) inactive time:	920 ms rx bytes:
 4400805 rx packets:	37312 tx bytes:	130131582 tx packets:	84801 tx
 retries:	0 tx failed:	0 signal:  	-42 dBm signal avg:	-43 dBm 
 Toffset:	33792059 us tx bitrate:	6.0 MBit/s rx bitrate:	975.0
 MBit/s VHT-MCS 7 80MHz short GI VHT-NSS 3 mesh llid:	7963 mesh
 plid:	60395 mesh plink:	ESTAB mesh local PS mode:	ACTIVE mesh peer
 PS mode:	ACTIVE mesh non-peer PS mode:	ACTIVE authorized:	yes 
 authenticated:	yes preamble:	long WMM/WME:	yes MFP:		no TDLS peer:
 no connected time:	29 seconds
 
  anyway this thread will turn definitely
"lime-dev", and offtopic
 for lime-users, so I'm moving the discussion there :)
 
  If anyone has already tested this hardware or has
any tips,
 much welcome :)
 
 
 
 cheers!
 
 
 _______________________________________________ lime-users
 mailing list lime-users(a)lists.libremesh.org 
 
https://lists.libremesh.org/mailman/listinfo/lime-users  
 _______________________________________________ lime-users
 mailing list lime-users(a)lists.libremesh.org 
 
https://lists.libremesh.org/mailman/listinfo/lime-users  
 _______________________________________________ lime-users mailing
 list lime-users(a)lists.libremesh.org 
 
https://lists.libremesh.org/mailman/listinfo/lime-users   
 _______________________________________________ lime-users mailing
 list lime-users(a)lists.libremesh.org