28 Mar
2017
28 Mar
'17
4:41 p.m.
On 28/03/17
16:13, James Lewis wrote:
> Now the quesiton is: how do we set one of the mesh devices to _take_
> DHCP through the LAN port rather than give it, and to be the 'gateway'
> device on the mesh network, and then what will happen with devices
> that subsequently connect to the mesh? How will they get their gateway
> set?
There are two ways in your case:
* configuring LibreMesh for using that ethernet port as WAN (as Pau is
going to write in the web); * otherwise just plugging the cable from the gateway
device into the
secondary port of Nanostation M2 (your model has 2 ethernet ports,
right?)
No, I have the little M2 which only has one ethernet port.
I do have eth0 and eth1 interfaces though - perhaps this firmware also
built for the
other M2 also and is expecting a second ethernet port:
Should i / can I disable eth1 interface?
Thanks!
James
Bye!
Ilario
_______________________________________________
lime-users mailing list
lime-users(a)lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users
--
-- lewis.james(a)gmail.com