Re: [lime-users] Can't access to the luci configuration panel at thisnode.info

Good afternoon again! I tried the proposed configuration on /etc/config/lime-node, done `lime-config` and `restart`. But, unfortunately, wifi is not working. Based on the output of the `lime-config` and `wifi status` command, and reading the documentation, I wonder if what I must do is create another radio and configure the mesh there. Also, I rollbacked the lime-node file changes, and checked the output of `wifi status`. Both APs and the mesh are configured on a single radio. Is that correct? So.. on a router like the TP-Link with 2 antennas, only one works? I mean, radio==antenna? Next is the output of `lime-config` and `wifi status`, with the suggested changes on lime-node: ---------------------------------------------------------------- root@LiMe-d64151:~# lime-config Clearing wireless config... Clearing network config... Disabling odhcpd sh: /etc/init.d/odhcpd: not found Cleaning dnsmasq Disabling 6relayd... No wan interface detected lime.proto.babeld.configure(...) Use fallback value for network.babeld_over_librenet6: false lime.proto.babeld.setup_interface(...)    wlan0-apname    ignored lime.proto.babeld.setup_interface(...)    wlan0-ap    ignored lime.proto.babeld.setup_interface(...)    eth0 Configuring system... Let uhttpd listen on IPv4/IPv6 ---------------------------------------------------------------- ---------------------------------------------------------------- root@LiMe-d64151:~# wifi status {     "radio0": {         "up": false,         "pending": false,         "autostart": true,         "disabled": false,         "retry_setup_failed": true,         "config": {             "channel": "11",             "hwmode": "11g",             "path": "bcma0:1",             "distance": 100,             "noscan": "1",             "noscan": true,             "disabled": false         },         "interfaces": [             {                 "section": "lm_wlan0_ap_radio0",                 "config": {                     "mode": "ap",                     "ifname": "wlan0-ap",                     "ssid": "LibreMesh.org",                     "mode": "ap",                     "network": [                         "lan"                     ]                 }             },             {                 "section": "lm_wlan0_apname_radio0",                 "config": {                     "mode": "ap",                     "ifname": "wlan0-apname",                     "ssid": "LibreMesh.org\/LiMe-d64151",                     "mode": "ap",                     "network": [                         "lan"                     ]                 }             }         ]     } } ---------------------------------------------------------------- Again, thanks in advance for your patience and help. Kind regards, Pedro. On 25.03.2020 05:57, Pedro Mauro wrote: _______________________________________________ lime-users mailing list lime-users(a)lists.libremesh.org https://lists.libremesh.org/mailman/listinfo/lime-users