2016-11-17 15:46 GMT+01:00 fred &lt;support(a)qo-op.com&gt;om>: > I am trying to use LiMe (chef cooked) on Bullet M2. > Succeed flashing, changing eth0 mode into dhcp client, other iinto dhcp > server. > > Whith one node only: > Me <------wlan-----> Mesh (LiMe) BULLETM2 <--eth--> Internet router > 10.109.160.104 ---10.109.0.1----192.168.1.32-------192.168.1.1 > > Connected to mesh, I have no route to Internet... How did you change the ethernet interface settings? For LibreMesh to start looking for internet connection on an interface it has to be configured as WAN in LibreMesh configuration files. This usually happens automagically when a router comes with a physical dedicated "WAN" port. In your case the Bullet comes with just one port, for setting it to WAN in LibreMesh you will have to add a specific configuration in /etc/config/lime file. Maybe there's also a way to do it in the web interface but I've never used it... You can find an example of specific interface configuration in /etc/config/lime-example or here: https://github.com/libremesh/lime-packages/blob/develop/packages/lime-syste… So, try adding the following lines to /etc/config/lime: config net eth0wan # the name here is not important option linux_name 'eth0' # in this case there's just one ethernet port, so no doubt that is eth0 list protocols 'wan' then remember to launch the command "lime-config" (which parses LiMe config and generates OpenWrt/LEDE config), reboot the router and now should detect and share the internet connected to the ethernet port :)