24 Dec
2016
24 Dec
'16
7:19 a.m.
Maybe a stupid question:
It is possible to add Lime to an existing Openwrt just by adding Lime repo
to the opkg config?
Juergen Kimmel <juergenkimmel(a)gmail.com> schrieb am Sa., 24. Dez. 2016 um
08:15 Uhr:
Eventually I tried to compile ramips.
So "make info" shows no mt7620 but here
https://github.com/libremesh/lime-build/blob/16.07/targets/mt7620
How come?
Juergen Kimmel <juergenkimmel(a)gmail.com> schrieb am Mi., 30. Nov. 2016 um
21:37 Uhr:
I tried with qMp trunk, no problem flashing, configuration produced some
headache but I went along. But afterwards probing internet access or even
lan access results in crashes. Sometimes devices recovered sometimes had to
be rebooted. Being a Noob I assume the lightest load leads to crash. There
are quite a lot error messages in the system log which I can't interprete.
What I read from the log there could be a Vlan problem as well as
automatic configuration of the wlan's fails at some point.
Ilario <iochesonome(a)gmail.com> schrieb am Mi., 30. Nov. 2016 um 20:35 Uhr:
2016-11-30 19:38 GMT+01:00 Juergen Kimmel <juergenkimmel(a)gmail.com>om>:
Hi all,
got 5 of this dualband CPE (MT7620a). Tried QMP firmware, flash ok but
crashes only by accessing internet.
Anybody here got those working?
It is not supported by last OpenWrt stable, so it's not yet supported
by LibreMesh (you could try with the develop branch).
Looks supported by both OpenWrt trunk and LEDE trunk.
Did you try with these?
_______________________________________________
lime-users mailing list
lime-users(a)lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users