Re: [lime-users] Captive portal

i couldn't get the nodogsplash from openwrt repos to work in libre-mesh. instead, i used this version, which was tweaked by gui to work in libre-mesh: opkg install http://chef.altermundi.net/downloads/r44952/ar71xx/packages/routing/nodogsp… with the config file listed below. but if you can make it work with the standard nodogsplash, please let us know. ------------ GatewayInterface br-lan GatewayInterfaceExtra bmx+ GatewayInterfaceExtra2 anygw FirewallRuleSet authenticated-users { FirewallRule allow to 0.0.0.0/0 } FirewallRuleSet users-to-router { # Nodogsplash automatically allows tcp to GatewayPort, # at GatewayAddress, to serve the splash page. # However you may want to open up other ports, e.g. # 53 for DNS and 67 for DHCP if the router itself is # providing these services. FirewallRule allow udp port 53 FirewallRule allow tcp port 53 FirewallRule allow udp port 67 # You may want to allow ssh, http, and https to the router # for administration from the GatewayInterface. If not, # comment these out. FirewallRule allow tcp port 22 FirewallRule allow tcp port 80 FirewallRule allow tcp port 443 } # end FirewallRuleSet users-to-router FirewallRuleSet preauthenticated-users { # For preauthenticated users to resolve IP addresses in their initial # request not using the router itself as a DNS server, # you probably want to allow port 53 udp and tcp for DNS. FirewallRule allow tcp port 53 FirewallRule allow udp port 53 # For splash page content not hosted on the router, you # will want to allow port 80 tcp to the remote host here. # Doing so circumvents the usual capture and redirect of # any port 80 request to this remote host. # Note that the remote host's numerical IP address must be known # and used here. #change the IP for the address of the gateway router FirewallRule allow tcp port 80 to 10.7.122.55 } # end FirewallRuleSet preauthenticated-users EmptyRuleSetPolicy preauthenticated-users passthrough EmptyRuleSetPolicy users-to-router passthrough #change the IP for the address of the gateway router GatewayName 10.7.122.55:80 #GatewayPort 80 MaxClients 500 ClientIdleTimeout 720 ClientForceTimeout 14400 #change the range for the ip range of your mesh network GatewayIPRange 10.7.0.0/16 BinVoucher "vale.sh" ForceVoucher yes EnablePreAuth yes #change to the place where you want to redirect the users after login RedirectURL http://www.quintanalibre.org.ar/portada ---------- On Mon, Dec 12, 2016 at 11:47 AM, Ilario <iochesonome(a)gmail.com> wrote: -- bruno(a)pobox.com ▀─█▄██▄▀▄ http://brunovianna.net ─█▄██▄▀█▀█▄ skype: randomico▀─█▄██▄▀█▀█▄▌██─█▌█▌