16 Jul
2017
16 Jul
'17
2:16 p.m.
in the same room, the wdr3500 and cpe510 connected with more than 100mb/,
although it's odd that they never show the same speed on both sides. is
there any way better than iwinfo to check it?
cpe510:
wlan0-adhoc ESSID: "LiMe"
Access Point: CA:FE:00:C0:FF:EE
Mode: Ad-Hoc Channel: 48 (5.240 GHz)
Tx-Power: 10 dBm Link Quality: 67/70
Signal: -43 dBm Noise: -95 dBm
Bit Rate: 108.0 MBit/s
Encryption: unknown
Type: nl80211 HW Mode(s): 802.11an
Hardware: unknown [Generic MAC80211]
TX power offset: unknown
Frequency offset: unknown
Supports VAPs: yes PHY name: phy0
wdr3500:
wlan1-adhoc ESSID: "LiMe"
Access Point: CA:FE:00:C0:FF:EE
Mode: Ad-Hoc Channel: 48 (5.240 GHz)
Tx-Power: 15 dBm Link Quality: 68/70
Signal: -42 dBm Noise: -90 dBm
Bit Rate: 180.0 MBit/s
Encryption: unknown
Type: nl80211 HW Mode(s): 802.11an
Hardware: 168C:0033 168C:A120 [Atheros AR9580]
TX power offset: none
Frequency offset: none
Supports VAPs: yes PHY name: phy1
I confirm 15mb in the 2km connection, but it was made between two cpe510s
with original firmware (not flashed), not between wdr and cpe. and they
were not aligned, but about 30-40 degrees offset.
i hope it helps!
bruno
On Sat, Jul 15, 2017 at 2:49 PM, Leonardo Taborda <
leonardotaborda(a)networkbogota.org> wrote:
yeah, the link speed. Can you confirm 15mb over 2km is
between the cpe510
and the wdr3500?. I like that cpe but i know some features of it may get
lost when using openwrt.
El 15/07/17 a las 12:37, bruno vianna escribió:
do you mean the link speed between two of them?
right now it is only 15mb over 2km, but thats because we wanted to have a
point-to-multipoint setup. so they're not pointed perfectly to each other,
but on the 45 degrees limit. but that might change as we keep looking for
other topographies for the network.
On Fri, Jul 14, 2017 at 10:00 AM, Leonardo Taborda <leonardotaborda@
networkbogota.org> wrote:
--
bruno(a)pobox.com ▀─█▄██▄▀▄
http://brunovianna.net ─█▄██▄▀█▀█▄
skype: randomico▀─█▄██▄▀█▀█▄▌██─█▌█▌
hi bruno
which speeds do you get with that device?
thanks
El 13/07/17 a las 18:22, Nicolas Pace escribió:
Great Bruno!
That sounds Amazing!
Please, if you have any time tell us more about your deployment!.
On Thu, 2017-07-13 at 18:27 -0300, bruno vianna wrote:
The reason I'm flashing these is that we installed a small network in
a favela here last week, and
the wdr3500 didn't have enough reach. Not only the nearest nods were
far (anything from 200m to 2km), but also all the interference we
had (it's a really dense neighborhood) made any link with more than
100m very poor. The plan now is to connect the most important nodes
with those.
Are you using the antenna that comes from factory, or using a custom
made one?
_______________________________________________
lime-users mailing
listlime-users@lists.libremesh.orghttps://lists.libremesh.org/mailman/listinfo/lime-users
--
Cordialmente
Leonardo Taborda Ángelleonardotaborda(a)networkbogota.orgwww.networkbogota.org
"When there is a will, there is a way"
_______________________________________________
lime-users mailing list
lime-users(a)lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users
--
bruno(a)pobox.com ▀─█▄██▄▀▄
http://brunovianna.net ─█▄██▄▀█▀█▄
skype: randomico▀─█▄██▄▀█▀█▄▌██─█▌█▌
_______________________________________________
lime-users mailing
listlime-users@lists.libremesh.orghttps://lists.libremesh.org/mailman/listinfo/lime-users
--
Cordialmente
Leonardo Taborda Ángelleonardotaborda(a)networkbogota.orgwww.networkbogota.org
"When there is a will, there is a way"
_______________________________________________
lime-users mailing list
lime-users(a)lists.libremesh.org
https://lists.libremesh.org/mailman/listinfo/lime-users