Hello lime friends I am messing with a libremesh router, wdr3500 and wdr3600. On those devices i flashed an image cooked on the chef, getting the same ip on both devices: 10.148.0.1. I tried to change the ip on Simple Config / Advanced, with no luck. If I try to modify the values on the IPV4 field, they apparently are kept, but reviewing the interfaces the same ip remains, so route -n in any client shows the same IP. Then I downloaded a generic image from http://downloads.libre-mesh.org/community_chaos/ where then I can set a different IP following the same steps. I want to know how's the procedure to change a nodes' ip, or get to know if i am doing wrong the way i did. This is a problem for me because i am setting the librenet6 tunnel, so both routers get the same anygw iov6 address. Thanks! -- Cordialmente Leonardo Taborda Ángel leonardotaborda(a)networkbogota.org www.networkbogota.org "When there is a will, there is a way" _______________________________________________ lime-users mailing list lime-users(a)lists.libremesh.org https://lists.libremesh.org/mailman/listinfo/lime-users

I am messing with a libremesh router, wdr3500 and wdr3600. On those devices i flashed an image cooked on the chef, getting the same ip on both devices: 10.148.0.1. I tried to change the ip on Simple Config / Advanced, with no luck. If I try to modify the values on the IPV4 field, they apparently are kept, but reviewing the interfaces the same ip remains, so route -n in any client shows the same IP.